User manual

computer radio control system
EN
3.3.
8.8 RC-Switch
The RC Switch is a special wireless device that allows you to remotely
connect or disconnect the receiver power supply of your model.
There are currently two variants of the device: RC Switch and RC
Power Switch. The difference is noticeable in the picture below. The
simple RC Switch is suitable for applications where a Central Box,
Max Bec 2D plus, SBEC 40 or other intelligent electronic device is
being used. It offers a single output pin that might be wirelessly
driven high or low according to the situation.
When connected in place of a magnetic key, the RC Switch can turn
the electronics in the model on and off.
Variant of the RC Switch
RC Switch
Magnetic key plug
RC Power Switch
Standard receiver
Receiver battery
Central Box
Max Bec 2D
SBEC 40, etc.
Battery plug
Power In
Power Out
This text describes receiver properties introduced in
DC/DS V3.0 and receivers version 3.20. Earlier versions
of the firmware might offer different properties, or the
described configuration might be entirely inaccessible.
Receiver software is updated through a PC with the aid of
the JETI USBa adapter. For more details refer to the USBa
adapter manual.
Note:
The second variant, the RC Power Switch, can fully replace a standard
physical switch. It can directly drive servos and electronics since it
includes a couple of low-resistant MOSFETS. Just plug the RC Power
Switch between the battery and the receiver, configure the switch-
related settings in your transmitter and bind it as a standard receiver.
The switch-related settings are located in Model-> Device Explorer -
> RC-Switch. First, you have to enable the switch by pushing the
rotary button on your transmitter with the first row of the transmitter
display highlighted.
Then you should bind the RC Switch:
• Put the bind plug into RC Switch and then turn it on.
• Push the rotary button with the "Pair RC Switch" row
highlighted on your transmitter display.
• The ID of the switch is automatically saved.
The Transmitter control switch function is a source of events:
If you want to turn the model on, then flip the assigned control
switch and confirm the question that appears. If you want to turn the
model off, just flip the switch back and also confirm the question.
You can invert polarity of the switch (if high logical level doesn’t turn
the device on) and also set the audible signals that will be activated
every time the status of RC Switch is changed (turned on or off).
65