User manual

computer radio control system
EN
This function cannot in any case be used to increase
safety, eg. against the theft of the transmitter. The
transmitter is locked against configuration changes
from the moment you enter the code until the
transmitter is subsequently switched off or the code is re-
entered. As soon as the transmitter is switched off, (eg.
pushing the combination of POWER+ESC or removing
the power supply), the transmitter is automatically
unlocked.
Note:
4. 4.
9.0.1 Pa sswo rd protection again st accidenta l
configuration changes
If you lend the transmitter to another person and you want to ensure
that no changes in the model configuration that could influence the
function of the transmitter or the model can be done, you can take
advantage of the Model Lock function.
1. In the main menu, push the „F4" button
to display the dialog for entering the one-
time password.
2. Here, enter the two-digit code using the
"F1" 1/2/3, "F2" 4/5/6 and "F3" 7/8/9. This
code appears on the display and will later
be used to unlock the transmitter.
Pushing „F4” Clear enables you to delete
the specified number and you can start up
again.
3. Remember the code and push „F5" OK.
Now confirm the safety prompt “Apply
changes?”.
From now on the transmitter will be
locked against:
- changes in configuration
- selection of the model
- creating a new model
4. Unlocking the model is possible via the
„F4" button in the Main Menu. Now you
need to enter the same code as when
locking the model. Confirm with „OK”
button.
Now you are asked whether you want to save the changes to the
configuration of the model or not.
Pushing „F1" NO button makes all the changes discarded and all the
data from the SD card will be reloaded.
- calibration of controls
- logging telemetry
- USB connection
- switching off
All the work with the SD card therefore takes place in read-only
mode.
68