User manual

computer radio control system

4. 4.

9.1.5 Swash mix

Here is where you set up the swashplate CCPM (=Cyclic/collective

pitch mixing) throws for Aileron, Elevator and Pitch. You can fine

tune each of these functions by changing their percentages. If

needed, you can reverse the throws by setting a negative

percentage.

If you activate the additional function of the gyro in the

active model, after leaving the Basic Properties menu it

is necessary to carry out the control assignment

(Functions Assignment) and then select the appropriate

output channel (Servo Assignment). Setting the gyro

gain itself is carried out in the „Fine Tuning-> Gyro

Setting menu”.

Note:

Swash Ring

It is possible to activate the function of the cyclic limitation for a

helicopter rotor head. Activating this function causes the restriction

of servo travel in the combined full deflection of the roll and pitch

controls so that the total size of the deflection is always within the

inner area of the displayed circle. Outside the circle there is a kind of a

dead zone of the flight controls.

Editing an item "Value" affects the diameter of the displayed circle,

ie. size of the maximum allowed deflection. The setting is global for

the whole model.

1. Number of Motors in the Model

This is where you select the number of motors in your model. It is

possible to select 0-4 motors. The number of transmitter control

outputs used to control the motors are automatically increased or

decreased according to number of motors that you select.

2. Motor Type

Do the motors in your model only turn in one direction or are they

able to rotate in both directions?

9.1.6 Basic Configuration-GENERAL