User manual

computer radio control system

4. 4.

9.2.12 Governor/Gyro (*depends on equipment)

Typically, a gyro is used to stablize a model helicopter along its

vertical axis (rudder). One channel is reserved so that you may adjust

the gyro sensitivity (gain) from the transmitter. Also, a separate

channel can be reserved for the control of a throttle governor. The

governor can be enabled when you create the model or later from

the „Model >Basic Properties“ menu. This menu allows you to

adjust the settings for both of these output channels. The

Governor/Gyro settings can be set collectively for all flight modes by

selecting the “G-(globe)” symbol or you can allow individual

Governor/Gyro settings in each separate flight mode by sellecting

the “S-Separate” symbol.

1. Gyro Settings

By default, the gyro sensitivity is assigned to the three position „Si“

switch. This allows you to have three different settings (Position 1,

Position 2, Position 3) for the gyro sensitivity. You can always assign

this function to a different transmitter control element (knob, slider,

switch) in the „Model, >Function Assignment“ menu. The Gyro

settings can be set collectively for all flight modes by selecting the

“G-(globe)” symbol or you can allow individual Gyro settings in

each separate flight mode by sellecting the “S-Separate” symbol.

In the Gyro settings menu it is possible to edit up to three main

values for each gyro function in all flight modes separately according

to the position of the main control/switch.

Moving the switch to the selected position causes an automatic

update of the depicted values in the appropriate line. Set the main

value of the gyro gain to the needed value (highlighted in the

picture), eventually also assign an appropriate control for fine tuning

– here it is necessary to set also the percentage range of the control

influence. For each position of the main control it is possible to

individually assign an independent control for fine tuning of the

gyro gain. The resulting applied gain value is displayed in

parentheses (-50% in this case).

Negative values of gyro gain indicate the gain in

"Normal" mode, positive values indicate the gain in the

"Heading-lock" mode.

Note:

If you have the governor function enabled, by default, the governor

sensitivity is assigned to the three position „Sg“ switch. This allows

2. Governor Settings