User's Manual

Jetlun Corporation
Jetlun Gateway User Guide rev 0.3 DRAFT
23


RD71206

Zigbee devices that support remote on/off command functions will show
High or Medium or Low or OFF or ON in their Status column if they are
connected and OFFLINE if they are not connected. If showing
High/Medium/Low/OFF, click High/Medium/Low/OFF allows you to
remotely switch that device off or high or medium or low.
Zigbee devices that do not have remote command functionality will show
as OFFLINE(disconnected) or Humidity&Temperature(connected).
In the case of an OFFLINE status setting, make sure to check that the
device is plugged directly into a power outlet. Ensure that no switching
power supplies are nearby, as they can interfere with powerline
connectivity.
When a device first joins the network but has not been authenticated, you
will see it listed but grayed out, as illustrated in the top row (eg: Circuit
Meter) of Figure 17. To authenticate onto the network, click on DISABLE
(under the Auth column) and it will automatically change to say ENABLE
in green text.
To customize each device on the Home Area Network, click on the [edit]
icon in the Operate column. A pop-up window will appear and allow you
to name the device, specify the device zone, and create a custom name
for each sensor.
To remove or delete a device from the Home Area Network, click on the
[delete] icon under the Operate column in that device’s row.
WARNING: If the zigbee device is deleted, that device
can not join the network anymore otherwise the network
is rebuilt.
To configure device automatic service, click on the [auto service] icon in
the Operate column. A pop-up window will appear and allow you to define
the time, day and operation (on or off)
To configure zigbee device permission, click on the [zigbee network] icon
in the Operate column. A pop-up window will appear and allow you to
change the Channel ID, Power Level and Pan ID.
WARNING: If the zigbee device permission is not the
same as that in the setup->zigbee, the zigbee device will
leave the network
To configure the Thermostat, click on the [Thermostat] icon in the
Operate column. A pop-up window will appear and allow you to select the
option you want.
NOTE: The Home Area Network > Network Overview
screen automatically refreshes every 60 seconds. During
initial setup, it may take a few minutes for the Energy
Manager Plus to register the devices on the network.
批注 [z1]: New add
批注
[z2]: New add