User's Manual

Jetlun Corporation
Jetlun ZigBee Appliance Plus User Guide Draft
9


DOC: UG-RD71316-draft

3.0 INSTALLING THE JETLUN APPLIANCE PLUS
3.1 Installing the ZigBee GreenPHY Appliance Module Plus Hardware
Follow these quick steps to install your ZigBee GreenPHY Appliance Module Plus
NOTE: There are two devices DUT1 and DUT2 connecting to
ZigBee GreenPHY Appliance Module Plus. Relay 1 is used to
control DUT1, and Relay 2 is used to control DUT2
 STEP 1: Connect the line for power to Line 1 in (Black wire) for ZigBee GreenPHY
Appliance Module Plus
 STEP 2: Connect the Neture for power to Line 2 in / Neutral (Brown wire) for
ZigBee GreenPHY Appliance Module Plus
 STEP 3: Connect the Line 1 out High (Red wire) for ZigBee GreenPHY Appliance
Module Plus to Line for DUT2
 STEP 4: Connect the Line 1 out Low (Yellow wire) for ZigBee GreenPHY
Appliance Module Plus to Line for DUT1
 STEP 5: Connect the Line 2 out/Neutral (Blue wire) for ZigBee GreenPHY
Appliance Module Plus to Neutral for DUT2 and DUT1
 STEP 6: Plug in the ZigBee GreenPHY Appliance Module Plus to a nearby power
outlet and the ZigBee GreenPHY Appliance Module Plus’s ZigBee LED
will be lit solid green for 15 seconds.
3.2 Join and Leave the ZigBee GreenPHY Appliance Plus
3.2.1 Join the Network
 STEP 1: The ZigBee GreenPHY Appliance plus will automatically search for any
available ZigBee network upon power up, indicated by the blinking orange
LED on the Power/ZigBee LED.
Line1
Line2/Neutral
Line1 in (Black)
RD71316
Line 2 in (Brown)
Line1 out High (Red)
Line1 out Low (Yellow)
Line 2 out Neutral (Blue)
Line
Line
Neutral
DUT2
DUT1