User's Manual

Jetlun Corporation
Jetlun Appliance Module User Guide rev 1.0 DRAFT
7
!
!
!
RD75613
!
Table 3: Front Panel LED Description
The Power LED lights up GREEN and will stay on while the
Appliance Module is powered on. When the Appliance Module
goes through its self-diagnostic mode during every boot-up, this
LED will flash GREEN. When the diagnostic cycle is complete,
the LED will be GREEN and solidly lit. When the Appliance
Module is operating on battery, the LED will flash RED. When the
Appliance Module is recharging the battery, the LED will flash
GREEN.
The Zigbee LED continuously lights up GREEN when the
Appliance Module is successfully connected to another Zigbee
device on the network. If the LED is flashing, the Appliance
Module is actively sending or receiving data over the network. If
the LED is flashing RED, the Appliance Module is experiencing
collisions on the network.
The HomePlug LED continuously lights up GREEN when the
Appliance Module is successfully connected to another
HomePlug device on the network. If the LED is flashing, the
Appliance Module is actively sending or receiving data over the
network. If the LED is flashing RED, the Appliance Module is
experiencing collisions on the network.
The Zigbee Security LED is lit GREEN when it is connected to a
Zigbee device on the network. If the LED is OFF, then the
Appliance Module is not connected to a Zigbee network.
2.3 Bottom Panel
Figure 2: Bottom Panel of the Gateway