User's Manual

Jetlun Corporation
Jetlun Appliance Module User Guide rev 1.0 DRAFT
9
!
!
!
RD75613
!
3.0 INSTALLING THE JETLUN APPLIANCE MODULE
Follow these quick steps to install your Jetlun Appliance Module.
3.1 Connecting the Jetlun Appliance Module to your Router
 STEP 1: Turn ON the battery switch located on the bottom panel of the Appliance
Module.
 STEP 2: Plug the Appliance Module directly into a wall socket.
IMPORTANT: Do not plug the Appliance Module into a UPS, power
strip, or other similar device with surge protection. The Appliance
Module has its own power filter for protection against surges.
 STEP 4: Refer to the Jetlun Gateway RD75606 User Guide on how to monitor and
control the Appliance Module through the Jetlun Gateway User Interface.
3.2 Joining a Zigbee Network
 STEP 1: With the Appliance Module plugged into the wall socket, press and hold
the Zigbee security button located on the bottom panel of the Appliance
Module for four (4) seconds or until the Zigbee security LED is lit on the
front panel of the Appliance Module.
3.3 Leaving a Zigbee Network
 STEP 1: With the Appliance Module plugged into the wall socket, press and hold
the Zigbee security button located on the bottom panel of the Appliance
Module for seven (7) seconds or until the Zigbee security LED is OFF on
the front panel of the Appliance Module.