User Guide

13
This motherboard provides two 168-pin DUAL INLINE MEMORY MODULES
(DIMM) sites for memory expansion available from minimum memory size of 16MB
to maximum memory size of 1GB SDRAM.
Valid Memory Configurations
Bank 168-Pin DIMM Total Memory
Bank 0, 1
(DIMM1)
SDRAM 32, 64, 128, 256, 512MB X 1 16MB
∼
512MB
Bank 2, 3
(DIMM2)
SDRAM 32, 64, 128, 256, 512MB X 1 16MB
∼
512MB
Total System Memory (Max. 1GB) 16MB
∼
1GB
Generally, installing SDRAM modules to your motherboard is very easy, you can
refer to figure 2-4 to see what a 168-Pin PC100 & PC133 SDRAM module looks like.
DI MM2 (BANK2+ BANK3)
DIMM1
(
BANK0 + BANK1
)
NOTE!
When you install DIMM module fully into the DIMM socket the eject tab should
be locked into the DIMM module very firmly and fit into its indention on both
sides.
WARNING!
For the SDRAM CLOCK is set at 133MHz, use only PC133-compliant
DIMMs. When this motherboard operate at 133Mhz, most system will
not even boot if non-compliant modules are used because of the strict
timing issues, if your DIMM are not PC133-compliant, set the SDRAM
clock to 100MHz to ensure system stability.
2-5 Expansion Cards
Figure 2-4