Operation Manual

TUNE R
FM
MONO
MHz
PM
MANUAL TUNING
1. Press “FUNCTIO N” button or “TUNER” button on remote control to enter
TUNER mode, then press /BAND” button to select desired BAND ( AM or FM ).
2. Tune to the desired station by pressing the or button.
3. Adjust volume level
by pressing VOL+/ -.
A
UTO TUNING
1. Press “FUNC TION“ butto n to enter TUNER mode then press
“ /BAND ” button to select the desired BAND ( AM or FM ).
2. Press and hold the or button for 1 - 2 seconds
and then release.
3. The unit will start seeking automatically and stop until a radio station is reached.
4. Repeat step 2 & 3 until the desired radio station is being reached.
5. Adjust volume level by pressing VOL+/ -.
P
RESET STATIONS BY REMOTE HANDSET
You can store up to total of 20 radio
stati ons in the memory (10-F M / 10-A M).
1. Set to TUNER mode.
2. Turn to the desired radio station by “MANUAL“ or “ AUTO “ tuni ng method.
3. Press
button PROG/ADJ
to enable programming state .
4. Press “
“
butto n
to select the desired
station memory for storage.
5. Press
PROG/ADJ
to confirm the setting.
6. Repeat step 2 to 5 to store other stations.
7. Press “
PRE- or PRE+
“ butt on to re-load the preset stations in order.
8. To return normal tuner mode, leave keys free.
F
M & FM-STEREO RECEPTION
Press the ST/MO butto n on remot e handset to select “MONO “or “STER EO “reception mode.
If selected mono “MONO ”, the indicator will show on display.
H
INTS F OR BEST RECEPTION:
-AM: the receiver has a buil t - in AM bar antenna. If AM reception is weak, slightly rotat e or
re-positioning of the unit will usually improve the AM reception.
-FM: the receiver has an attached FM wire antenna at the rear unit. This wire should be fully
unwound and extended at full length for best reception.
RADIO
LISTENING TO RADIO
7
ENGLISH
button
P
RE- or PRE+