Operation Manual

ENGLISH
29
PREPARATION
Unpacking and checking
• Remove the packing material and examine the unit for shipping damage.
• Do not operate if it is damaged in any way and bring it back to the dealer immediately.
• Check whether the delivery is complete.
• Keep the packaging, if possible, until the expiration of the warranty period.
• Make sure there is adequate ventilation. Keep a minimum distance of 5 cm around the device in order to
ensure sufficient cooling.
• Open the CD compartment (8) and remove the transportation support.
Mains operation
• Make sure that the FUNCTION switch (19) is set to position TAPE (OFF).
• Make sure the mains voltage matches the information on the rating label of the device.
• Plug the power cord into an appropriate outlet. In delivery status the power cord may be located inside the
battery compartment (14).
• To completely disconnect from the mains power, pull the plug from the outlet.
• Do not operate the device by battery and mains power at the same time.
Battery operation
• To operate the device with batteries, you will need 6 x 1.5V batteries type C/UM-2/LR14.
• Open the battery compartment (14) at the bottom of the device and insert the batteries.
• Check carefully for the correct polarity (+/-) according to the imprint.
• Close the battery compartment after the batteries are inserted.
• Remove all batteries, if you operate the device with the power plug.
• Remove the batteries, if you will not use the device for an extended period of time in order to prevent
damage.
• Read the safety instructions for using batteries (see chapter Important Safety Instructions).
OPEN OPEN
Fig. 1
JGC-RRMP-6910-IM-DE-EN-V2.indb 29 11/08/2009 1:13 PM