User Guide

JHS PEDAL MANUAL 16
PREAMP
Haunting Mids
The Haunting Mids is a frightfully effective sweepable mids EQ pedal that can turn any
amp or pedal into a midrange monster. With its ability to sweep mids and then boost/
scoop them, you can nd the ghastly tone that haunts your imagination.
Controls
POWER - Uses 9V DC Negative Center. Do not use more than 9V DC. Your warranty will be voided.
13mA consumption.
VOLUME - Controls the overall volume of the unit.
MIDS - Controls how much the mids are boosted or
scooped.
SWEEP - Controls which mid frequencies are boosted or
scooped by the Mids knob. Below noon is low-mids,
above noon is high-mids.
LO/HI TOGGLE - Acts as a “Q” function by setting the
width and sharpness of the frequency curve. HI is a
sharp/narrow peak for a pronounced affect and LO is a
wider/softer peak for a slightly more subtle and
balanced effect.
Jacks
INPut - 1/4” jack on the right side of the pedal. output - 1/4” jack on the left side of the pedal.
Th e Cray on
British voiced preamp distortion, fuzz, overdrive, and boost in a versatile small
footprint that follows in the shadow of the our Colour Box. Looking for a different dirt
sound? Look no further.
Controls
POWER - Uses 9V DC Negative Center. Do not use more than 9V DC. Your warranty will be voided. 15mA
consumption.
Master - Controls the output volume.
Pre-Vol - Works as a drive or fuzz control like turning up
the pre-volume on a preamp. As you reach 75% and
above, the fuzz will begin to gate out when picking the
strings harder.
Tilt - Active tone control that is at when the knob is at
50%. When turned to the left it will boost bass and
simultaneously cut treble. When turned to the right it
boosts treble and cuts bass.
INPUT - Jack on the right side of the pedal.
OUTPUT - Jack on the left side of the pedal.
Jacks