User Guide
JHS PEDAL MANUAL 7
Twin Twelve v2
For the rst time ever, the legendary tones of the Silvertone 1484 amplier are at your feet. Rich
preamp/overdrive tones with a unique voice and character not found in any other pedal on the
market.
Controls
POWER
- Uses 9V DC Negative Center. The Twin Twelve is internally charged to 18V. Do not use more than 9V DC. Your
warranty will be voided. 34mA consumption.
VOLUME
- Controls the output volume.
DRIVE - Controls the amount of drive or gain just
like a tube amp being cranked at high volumes.
BASS - This is an active bass control just like the one you
would nd on the classic amp, modied for a more
usable sweep. Left is less, right is more
TREBLE - Active treble control just like the amp. Left is
less, right is more.
CLEAN/DIRT TOGGLE - Switches between clean preamp
boost and overdrive mode. The LED is blue when in
Clean mode and is red to indicate you are in the Dirt
mode.
RED REMOTE JACK - The upper jack on the right side
of the pedal is for a JHS “Red Remote” switch. Using
this switch you can toggle between the Clean mode
and the Dirt mode on the y.
INPUT - Lower jack on the right side of the pedal.
OUTPUT - Jack on the left side of the pedal.
Jacks
COMPRESSION
Pulp n Peel v4
Studio grade compression that is truly transparent. Parallel clean blend for dialing in the perfect
attack, EQ control, DI and 1/4” parallel outputs, built in switchable buffer and even a distortion
circuit make The PnP V4 the ultimate end-all compressor for electric guitar and bass.
Controls
POWER - Uses 9V DC Negative Center. Do not use more than 9V DC. Your warranty will be voided. 32mA
consumption.
VOLUME - Controls the output volume.
COMP - Controls the amount of compression.
BLEND - Blends in compression. All the way right is full
compression/preamp tone while rolling it left brings in
your original uncompressed tone.
EQ - Darkens or brightens your tone. Right is brighter,
left is darker.
DIRT TOGGLE - Activates the overdrive circuit. The
amount of overdrive is controlled by the trim pot on the
right side of the pedal. Works in conjunction with the
blend control.
INPUT - 1/4” jack on the right side of the pedal.
1/4” OUTPUT - 1/4” jack on the left side of the pedal.
XLR OUTPUT - XLR jack on the left side of the pedal
for DI purposes with bass or acoustic instruments.
Jacks
GROUND LIFT - Small switch on left side. If the DI signal
creates a hum, this switch will take care of it.
BUFFER SWITCH - Small switch on right side. Turns the
internal bypass buffer on or off.
OVERDRIVE & DISTORTION