User Manual
JHS PEDAL MANUAL 5
OVERDRIVE & DISTORTION
Morning Glory v4
Transparent low/medium gain overdrive that never gets in the way. The overdrive
you’ve always wanted but could never nd.
Controls
POWER - Uses 9V DC Negative Center. Do not use more than 9V DC. Your warranty will be voided. 100mA
max consumption.
VOLUME - Controls the output volume.
DRIVE - Controls the amount of drive or gain just
like a tube amp being cranked at high volumes. You will
notice that as you turn up the drive, it also adds
brightness.
TONE - Controls the amount of brightness. Right is
brighter, left is darker.
GAIN TOGGLE - Engages higher gain mode when
ipped up. The LED will turn red to indicate that you are
in the higher gain mode.
RED REMOTE JACK - The upper jack on the right side
of the pedal is for a JHS “Red Remote” switch. Using
this switch you can toggle between the higher gain
mode and the standard mode on the y.
INPUT - Lower jack on the right side of the pedal.
OUTPUT - Jack on the left side of the pedal.
Jacks
BRIGHT CUT SWITCH
- Switch on the right side of the
pedal that cuts the highest frequencies in case the
overall tone is too bright.
Steak & Eggs
With these modied classic overdrive and compression circuits in one box, the Steak
and Eggs is the perfect staple for your pantry. Marinate your ears and incubate your
tone with the Steak and Eggs.
POWER - Uses 9V DC Negative Center. Do not use more than 9V DC. Your warranty will be voided. 100mA
max consumption.
JACKS
INPUT - Jack on the top right of the pedal. OUTPUT - Jack on the top left of the pedal.
JHS Morning Glory w/High Gain Toggle
Volume - Controls the output volume.
Drive - Controls the amount of drive, or gain, just
like a tube amp being cranked at high volumes.
You will notice that as you turn up the drive it
also adds brightness.
Tone - Controls the amount of brightness. Right
is brighter, left is darker.
High Gain Toggle - Down is the standard
Morning Glory, up kicks it into high gain mode!
LEFT SIDE
Keeley Electronics 3 Knob Compressor
Level - Controls the output level.
Sustain -
Controls the sustain of the
compression. Turning to the right results in a
more compressed tone.
Blend -
Blends in your original signal as you turn
to the right.
Bright Toggle
- Down is the stock position. When
pushed up it will add brightness to your signal.
RIGHT SIDE
Sweet Tea V2
Everything possible, medium to high gain. Classic 808 tube screamer tones and our
very own Angry Charlie inside this one compact design.
Controls
POWER - Uses 9V DC Negative Center. Do not use more than 9V DC. Your warranty will be voided. 100mA
consumption.
Left Side - Angry Charlie
Volume - Controls the output volume.
Drive - Controls the amount of drive or gain just
like a tube amp being cranked at high volumes.
Tone - This is a tone cut like you would nd on an
amp. Left is brighter, right is darker.
Presence - Just like the presence knob on an amp, this
allows you to dial in the perfect amount of high end for
compatibility with any amp. It works as a presence cut,
left is brighter, right is darker.
Right Side - JHS 808
Volume - Controls the output volume.
Drive - Controls the amount of drive or gain just
like a tube amp being cranked at high volumes.
Tone - Controls the amount of brightness. Right is
brighter, left is darker.
3 Way Gain Toggle - Down is stock saturated mode,
middle is boost mode, and up is crunch mode.
JACKS
Input - 1/4” jack on the right side of the pedal.
Output - 1/4” jack on the left side of the pedal.
Superbolt v2
Supro* tones in a pedal and a whole lot more! This discreet circuit does everything
from clean boost to sagging exploding small amp distortion with ease.
*The word/name Supro is a registered trademark of Pigtronix. The JHS SuperBolt pedal is in no way affiliated with Supro® USA or Pigtronix.
Controls
POWER - Uses 9V DC Negative Center. The SuperBolt is internally charged to 18V. Do not use more than
9V DC. Your warranty will be voided. 100mA max consumption.
VOLUME - Controls the output volume.
DRIVE - Controls the amount of drive or gain just
like a tube amp being cranked at high volumes.
TONE - Increases brightness. Right is brighter, left is
darker.
GAIN TOGGLE - Engages higher gain mode when
ipped up. The LED will turn red to indicate that you are
in the higher gain mode.
RED REMOTE JACK - The upper jack on the right side
of the pedal is for a JHS “Red Remote” switch. Using
this switch you can toggle between the higher gain
mode and the standard mode on the y.
INPUT - Lower jack on the right side of the pedal.
OUTPUT - Jack on the left side of the pedal.
Jacks