User Manual

JHS PEDAL MANUAL 6
OVERDRIVE & DISTORTION
The AT
Andy Timmons signature channel drive. British style overdrive and distortion that will
have your guitar singing like Andy’s!
Controls
POWER - Uses 9V DC Negative Center. This pedal CAN be run at 18v for more headroom and greater
dynamics. Do not use more than 18V DC. Your warranty will be voided. 100mA consumption.
Volume - Controls the output volume.
Drive - Controls the amount of drive, or gain, just 
like a tube amp being cranked at high volumes.
EQ - High pass lter that naturally brightens or darkens
the overall tone of the pedal. Right is brighter, left is
darker.
Air - Just like the presence knob on an amp, this allows
you to dial in the perfect amount of high end for
compatibility with any amp. Right is brighter, left is
darker.
INPUT - Jack on the right side of the pedal.
OUTPUT - Jack on the left side of the pedal.
Jacks
Twin Twelve v2
For the rst time ever, the legendary tones of the Silvertone 1484 amplier are at your feet. Rich
preamp/overdrive tones with a unique voice and character not found in any other pedal on the
market.
Controls
POWER - Uses 9V DC Negative Center. The Twin Twelve is internally charged to 18V. Do not use more than 9V DC. Your
warranty will be voided. 100mA max consumption.
VOLUME - Controls the output volume.
DRIVE - Controls the amount of drive or gain just 
like a tube amp being cranked at high volumes.
BASS - This is an active bass control just like the one you
would nd on the classic amp, modied for a more
usable sweep. Left is less, right is more
TREBLE - Active treble control just like the amp. Left is
less, right is more.
CLEAN/DIRT TOGGLE - Switches between clean preamp
boost and overdrive mode. The LED is blue when in
Clean mode and is red to indicate you are in the Dirt
mode.
RED REMOTE JACK - The upper jack on the right side
of the pedal is for a JHS “Red Remote” switch. Using
this switch you can toggle between the Clean mode
and the Dirt mode on the y.
INPUT - Lower jack on the right side of the pedal.
OUTPUT - Jack on the left side of the pedal.
Jacks
The kilt
A tone tweakers dream pedal. Boost, overdrive, distortion, fuzz and spitting
chaos in one box. Don't be seen without your Kilt on.
Controls
POWER - Uses 9V DC Negative Center. Do not use more than 9V DC. Your warranty will be voided. 100mA
max consumption.
FOOTSWITCHES
Left Footswitch - Engages the left “dirt” side.
Right Footswitch - Engages the right “boost” side.
KNOBS
Left “Dirt” Side
Volume - Controls the output volume.
Tone - Controls the amount of brightness. Right is
brighter, left is darker.
Gain - Controls the amount of drive, or distortion.
Right “Boost” Side
Boost - Controls the output volume of the boost. The
boost will add just a slight amount of grit to your signal.
Toggles
Low Cut Toggle - The down position is the stock mode
with the most bass. The up position is the “cut” mode
with less bass.
G1 & G2 Toggles - These toggles work together to give
you up to 4 different resistance clipping options. Both
toggles down is the lowest gain setting. G1 up gives
you more overdrive. G2 up gives you more fuzz. Both
toggles up gives you the heaviest gated fuzz the Kilt
offers!
Order Toggle - Selects the order of the two effects.
Down is Boost > Dirt, up is Dirt > Boost.
Jacks
INPUT - Jack on the right side of the pedal.
OUTPUT - Jack on the left side of the pedal.