User's Manual
Table Of Contents
- CHAPTER 1 INTRODUCTION
- CHAPTER 2 INSTALLATION
- CHAPTER 3 NORMAL MODE AND USER MODE
- 3.1 Normal Mode
- 3.2 User Mode
- 3.3 The major menus
- 3.3.1 Sub-menus for Printer Info
- 3.3.2 Sub-menus for Head Info
- 3.3.3 Sub-menus for Version Info
- 3.3.4 Sub-menus for Printer Setup
- 3.3.5 Sub-menus for card setup
- 3.3.6 Sub-menus for Ribbon/Film Setup
- 3.3.7 Sub-menus for Image Setup
- 3.3.8 Sub-menus for Interface Setup
- 3.3.9 Sub-menus for Cleaning
- 3.3.10 Sub-menus for Option
- 3.3.11 Sub-menus for Reset User Default
- CHATPER 4 CLEANING
- CHATPER 5 TROUBLESHOOTING
- CHAPTER 6 SPECIFICATION
- Appendix I: OPTIONS
- Appendix II: FCC STATEMENT
- Appendix III: DASCOM REPRESENTATIVES
Dascom DC-7600 User Guide V1.0
To load a new ribbon onto cartridge,
place or engage orange spoolof
ribbon to feeding hub of the cartridge.
While unwinding the ribbon film,
route the film around three guiding
poles.
Finally engage the black spool to the
winding hub of cartridge.
Apply some force to push in the spools to the hubs.
The ribbon should be slightly tightened and not slanted.
As shown in the right diagram, push in
the ribbon cartridge to the far end until
a “click” is heard to indicate correct
insertion.
30