User's Manual

Tally Dascom 1430

Adjust Physical Margins

Adjust Page Margins allows for adjustments of physical left, top margins and tear-off position. Warning: Once

these settings are changed, resetting the printer to factory defaults will not initialize these settings back to

the original settings; so it is not advisable to perform this adjustment unless it is absolutely necessary.

Adjust Top Margin Procedure:

1. Enter the Adjust Page Margins function by holding down the【Load/Eject】and【Online】keys while

powering up until the printer beeps twice.

2. Load paper.

3. The printer will print as below:

Adjust Page Margins:

【LF/FF】=OK 【Tear/Off】= Back 【Load/Eject】= Next 【Online】= Exit

Current Setting: Adjust Fanfold Top Margin

Press【LF/FF】key to confirm selection if the paper used is fanfold type. The printer will print as

follows:

Procedure：

Install fanfold paper to tractors

【LF/FF】 = Add 【Load/Eject】 = Reduce 【Online】 = Exit

Each step is 0.5 mm

Function of keys:

【Te a r O f f 】key: Decrease 0.5mm

【Load/Eject】key: Increase 0.5mm

4. Press 【LF/FF】 key, printer will print “Save settings？Ye s ”. Press 【Load/Eject】 key to choose Yes

or No，then press 【LF/FF】 key to confirm selection and exit “Adjust Page Margins” mode by

pressing 【Online】. The print head moves to the left side and the printer beeps twice, then the print

head moves to the middle position.

Adjust Left Margin Procedure: