User's Manual

Tally Dascom 1430

Firmware Update

Sometimes it is necessary update the firmware to solve a problem. The latest firmware file may be obtained

from your dealer or downloaded from our website www.dascom.com. Before upgrading firmware, it is

strongly recommended to print the Main Menu page to keep a record of the old settings.

Note: Firmware update should only be performed by an authorized service person. We disclaim any

responsibility for any damage caused if it is performed by any other person.

To load new firmware, proceed as follows:

1. Switch off the printer. Connect your PC to the parallel port on the printer.

2. Press and hold down all 4 keys (S1, S2, S3, S4) while powering on the printer.

3. Alternate flashing of L1 and L2 LEDs indicates printer is ready for firmware update.

4. Go to the DOS prompt window. Copy the firmware file (with extension .MOT) to your printer as

follows:

COPY /B <filename>.mot PRN

5. When new firmware is being received, L1 and L2 will flash together, then followed by L1 and L3

flashing together.

Note: Do not interrupt the downloading process to prevent possible flash memory corruption.

6. When downloading is completed, the carriage returns to home position. Printer initializes normally.

Alternatively, you can use the Firmware Flash Tool version 3.5 or higher which is available in the CDROM and

our website as well. Upon starting up the tool, choose the correct file and press "Update".