User's Manual
Table Of Contents
- About This Manual
- 1 PRODUCT OVERVIEW
- 2 SETUP
- 3 INSTALLING DRIVER
- 3 CONNECTING TO COMPUTER
- 4 SETTING/CHECKING MODES
- 5 SETTING DIP SWITCHES
- 6 TROUBLESHOOTING
- 7 SPECIFICATIONS
- 8 CHARACTER CODE PAGES
- 8.1 Common to All Pages (International Character Set: USA)
- 8.2 International Character Sets
- 8.3 [User-defined page]
- 8.4 [PC437: USA, Standard Europe]
- 8.5 [PC850: Multilingual]
- 8.6 [PC852: Latin2]
- 8.7 [PC858: Euro]
- 8.8 [PC860: Portuguese]
- 8.9 [PC863: Canadian-French]
- 8.10 [PC865: Nordic]
- 8.11 [PC866: Cyrillic #2]
- 8.12 [KU42: Thai]
- 8.13 [TIS11: Thai]
- 8.14 [TIS18: Thai]
- 8.15 [PC720: Arabic]
- 8.16 [PC864: Arabic]
- 8.17 [WPC1256: Arabic]
- 9 PRINTING CONTROL COMMAND SETS
Tally Dascom DT-210/230 User Guide V1.3
26
3.4 For Parallel Interface
1. Insert the interface cable connector firmly into the interface connector on the
connector panel.
2. Press down the clips on either side of the connector to lock it in place.
3. When using interface cables equipped with a grounding line, attach the ground
line to the screw hole marked “FG” on the printer.
4. Connect the other end of the interface cable to the host computer.
3.5 For Ethernet Interface
NOTE!
Before installation, make you have installed the driver and the driver for Ethernet
interface (see Installing Driver on page 17)
Connect the printer to a network by a LAN cable via a hub.
Connect a 10/100BASE-T cable to the 10/100BASE-T LAN connector by pressing firmly until the
connector clicks into place.
When using the Ethernet interface, the network configuration is required. Make the settings on the
setup page.
• When LAN cables are installed outdoors, make sure devices without proper
surge protection are cushioned by being connected through devices that do