User's Manual

Tally Dascom DT-210/230 User Guide V1.3
50
2-4 BUSY Condition Receive Buffer Full
Offline or Receive
Buffer Full
OFF
2-5
Print Density See “Selecting the Print Density” on page 48.
OFF
2-6 OFF
2-7
OFF
2-8
Near-End Sensor Status
Disable
Enable
OFF
5.3 For Parallel and USB2.0 Interface
When using the serial interface, it is not necessary to change the DIP switch setting but their function
changes. For the details, see “For Serial Interface (RS-232C)” on page 47 .
DIP Switches Bank 1
SW Function ON OFF
Initial
setting
1-1
Auto Line Feed at CR
Enable
Disable
OFF
1-2
~
1-8
Reserved
-
- OFF
DIP Switches Bank 2
SW Function ON OFF
Initial
Setting
2-1 Reserved - - OFF
2-2 Internal bell control Internal bell disable Internal bell enable OFF
2-3
Auto Cutter
Disable
Enable
OFF
2-4 BUSY Condition Receive Buffer Full
Offline or
Receive
Buffer Enable
OFF
2-5
Print Density See “Selecting the Print Density” on page 53.
OFF
2-6
OFF
2-7
OFF
2-8
Near-End Sensor Status
Disable
Enable
OFF