NER700 series Robotic vacuum cleaner; household type Owner’s Guide Thank you for purchasing your new Eureka vacuum! Important instructions For easy assembly, please take a few moments to read this owner’s guide. If you have questions about your new vacuum, please contact our customer service HELPLINE at 1-800-282-2886. We’re here to help! Eureka stands by our Clean Promise seal. Learn more at www.eureka.com/cleanpromise www.eureka.
Write the model, type and serial number here: Date of purchase (keep your receipt) ______________ Model number and type _________________________ Serial number ________________________________ Find these numbers on a label on the hand vacuum, battery, and charger. Refer to these numbers when ordering parts and accessories, or if service is needed. : To register your product visit www.eureka.com link in the top right corner. : Carefully unpack and inspect your new Eureka vacuum cleaner for shipping damage.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. • Only operate the device in accordance with the instructions supplied. This device complies with FCC and IC radiation exposure limits set forth for an uncontrolled environment.
When using an electrical appliance, basic precautions should always be followed, including the following: This vacuum should not be used by children under the age of eight or those with reduced physical, sensory or mental capabilities without supervision. • Before using, clear area of power cords, pull cords for curtains or blinds, clothing and fragile items. • Do not operate in a room where a child or infant is sleeping. • Do not pour or spray any liquids on or in your robot.
Vacuum Left Charging base Adaptor Right 2 Spinning brushes HEPA Owner’s Manual Brush roll tool (inside vacuum) Rag Rag holder www.eureka.
Collision board Recharge Start / pause Navigation module Top cover Water tank Networking button Dust box release button Reset button Dust bin Cleaning brush Water tank release button Side brush Front Caster wheel Charging contact Brushroll Drive wheel Press power button for 1 seconds to turn robot on. When the robot is running press the power button to pause it. When robot is on, the power button will be lit up in white. To fully turn off the power, press and hold the power button for 3 seconds.
! Before running the robot, clear area of power cords, pull cords for curtains or blinds, clothing and fragile items. 1. Install the side brush before use Turn robot over and locate circle on both side, align the small circle of the spinner brush post in the center of the spinning brush and push until it clicks in place. Note: Left and right side bursh differs in color. 2. Install mopping tank I, disassemble wate tanke by pressing water tank release button.
Prepare your home Your robot uses an array of sensors to navigate around walls,furnitures legs,and other obstacles while it cleans. For best resukts,prepare your home firstly, clear area of power cords,pull cords for curtains and blinds, pull cords for curtains and blinds,clothing and fragile things. The robotic must be initially turned on before operating in any of the four control methods.
1. Finish Wi-Fi connecting following above wifi connect guideline 2.On the app's home screen, select Eureka NER700 3.On the next scree you will be able to use the buttons to start/stop cleaning; change modes,adjust suction power, recharging.
Regularly use a dry cloth to remove dust and debris from cliff sensors, charging contacts and sensors on front bumper to ensure they are not blocked. ! Never operate vacuum 1. Press dust cup release button to remove dust cup from robot. in proper position. Moving parts! Recharge cleaner after each use. 2. Open dust cup top lid and drop out dust. 3. HEPA filter is on the side of dust cup. 4. Have dust cup insert back to robot.
Midea America Corp. (“Eureka”), subject to the terms and conditions herein, warrants this vacuum cleaner to be free from defects in material and workmanship for a term of two years from the date of original purchase when used in accordance with the Eureka operating and maintenance instructions and under normal household usage. This warranty is granted only to the original purchaser and members of immediate household, and is applicable only to original purchases from Eureka authorized resellers.
! This vacuum cleaner has a special thermostat that protects the vacuum cleaner in case of motor , proceed as follows: 1) Check the vacuum for a overheating. period, press the power button. If the vacuum still does not work, call the 2) After the at 1-800-282-2886. Eureka Customer Service Motor will not start • Make sure cleaner is fully powered. • Push charger securely into electrical outlet, try another outlet or check circuit breaker. • See detailed “thermal cut-off” instructions above.
www.eureka.com Charger R0206 Charging base R0205 HEPA Filter R0204 Side brush set R0202 Brush roll R0201 Free 3 months extension of the original limited warranty period! Just text proof of purchase to 844 224 1614 * The extension is for the three months immediately following the @2020 Midea America Corp. Printed in China. www.eureka.