Reference Manual

79
System Failure Perform a soft reset
Rechargeable battery no
longer charges
Battery failure
Return to factory for repair and
replacement of batteries
Battery temperature too / too low
Keep the
battery at room
temperature
There's no sound Volume set too low or turned off Adjust the volume
The new PADAIR SHUTS
ITSELF DOWN
The new padAir is inactive
After a period of inactivity, the
mobile data terminal closes.
This time period can be set to
15S to 30Min, or it can never
sleep.
Battery's dead Charge the battery
New padAir reads Bar Code
undecoded
Scan utility program not enabled
Load the scan application in the
new padAir
In the bar code settings or
application settings interface
Set the scanner to the scan
screen, or hide the scanner
Bar Code unreadable
Make sure the bar code is free
of defects
Bar Code decoding function not
enabled
Go to the bar code setting and
open the corresponding
decoding
The new Padair does not support
this Barcode type decoding
The distance between the new
padAir and the bar code is not
appropriate.
Put the new padAir in the right
scan range.
I can't find any bluetooth
devices in the area
Too Far Away from other
Bluetooth devices
Move the device within 10
meters (32.8 feet) of another
Bluetooth device.
Nearby Bluetooth device not
turned on
Open the Bluetooth device you
are looking for
The Bluetooth device is not in
discoverable mode
Set The bluetooth
device to
discoverable mode
Unable to connect to AP
Show "problem with
authentication"
Wrong Wlan Password
Can't take a picture
Prompt "no storage device"
Exit from USB mode storage
mode
Warning: "Camera Malfunction. "
Turn off the scan, scan out the
light-time camera can not be
opened
Tip "INSUFFICIENT SD card Clear memory or switch