User's Manual

EW-HP-SW-01 Bluetooth Heart Rate Module
This user manual contains the instructions of EW-HP-SW-01 Bluetooth heart rate Module.
EW-HP-SW-01 is a very accurate heart rate sensor, which is equipped with Antoni’s sport clothes, The ECG measurement with the
highest quality and no interference can be realized. EW-HP-SW-01 connects and transmits data through Bluetooth® broadcast.
Heart rate sensor component
1.The plastic electrode area inside the clothing detects the heart rate..
2. The connector sends the heart rate signal to the receiving device.
After each use, detach the heart rate module from the clothes ,clean the clothes and dry module. Because sweat and moisture can wet the
electrodes and keep the heart rate sensor activated. This will reduce the battery life of the transmitter.
Wear heart rate sensor
TBD
Pair
The heart rate sensor needs to be directly connected and matched in CONDIXIO APP.
Pair the heart rate sensor with CONDIXIO:
1. Wear a sensor.
2.Open CONDIXIO APP on Android or iOS device
3. Go to the setup section of the APP and find the HR sensor. After finding your sensor, touch the' Connect' button to start connecting the device,
and it will turn into a green' connected' button after successful connection.
Sensor memory
The int
ernal memory of EW-HP-SW-01 can store heart rate data. In the offline state, the heart rate data can be stored in real time, and when
connected to the APP, the offline heart rate data can be transmitted to the APP.
When you go back to the blue tooth range that you have set up, EW-HP-SW-01 will automatically download your completed training from the
sensor and synchronize with your Flow diary.
If you have taken off the sensor from your clothes , re-connected it and put a sensor on your chest, you can connect it to CONDIXIO
and get the data smoothly transfer
Firmware
update
With CONDIXIO APP, we can update your sensor, improve its performance, or add new functions. Through the APP, you will be able to
upgrade the firmware. This update will not affect the RF function.
1. Click on the Bluetooth device name on the' Activity' page to enter the device details page.
2.If there is a new firmware, the green' Upgrade' button will appear at the bottom version number, and you can click it to start the upgrade.
3