Instructions / Assembly

8 Easy Wall boards
4 decorative outside corners
64 screws
Assembly support
Since EasyWall can be installed in either a 4’ x 4‘ or a 2’ x 8’ configuration,
plan the placement of the first board accordingly to allow proper space to build upwards.
2. Drive screws through the center groove and top leg (figure B) into wall studs.
Each 4’ panel requires eight screws.
3. Place next panel (top leg up, figure C) onto previously installed piece using the assembly
support connecting the two center grooves (see diagram on right), maintaining the proper
gap for hardware.
6. Remove backing from tape on decorative outside corners. Adhere two outside corners to each
vertical edge of completed 4' x 4' wall or one to each outside edge and one to each joining edge of
a 2' x 8' wall. Apply them to side edges with the adhesive sticking to the front of the Easy Wall panels.
Remove the assembly support and place in the next center groove.
10000286
near
4. Secure second board with screws as instructed in #2.
assembly
support
center
groove
board #1
board #2
Add your own accessories kit!