Operation Manual

98
HSP-14-GB(V2)
WARNING: Do not leave pool unattended while lling with water.
WARNING: If more than 1~2 inches of water collects on any one side before you
start lling in the center.The pool is not level enough, and must be corrected! You
shall pull out the drain plug, release the water completely, disassemble the pool
completely,locate the pool on a plane surface, repeat set up instructiion.
WARNING: DO NOT OVERFILL as this could cause the pool to collapse.In times of
heavy rainfall you may need to empty some of the water to ensure the level is correct.
PART5-FILL THE POOL WITH WATER
1. Make sure the drain tting is plugged securely and the cap
is in place. Start lling the pool with water. After about 1-inch of
water is on the bottom, stop lling and smooth wrinkles out of the
bottom of the pool. Pull the outer wall out from the top edge, all
around the bottom of the pool, so that it lls evenly.
2. Contineue lling the pool until water level..
PART4-SET UP THE POOL
Step5. INSTALL CANOPY(IF APPLICABLE)
Step6. TEST
Grab along the top of the frame and give the pool a shake to make sure all pins are locked in place.
Gently pull the bottom of each leg in an outward direction to make sure they are in an upright, verti-
cal position.
5
1
6
2
7
3
4
8
10
9
1. Cover the canopy on the frame you assembled
before.
2. Fasten the frame with all the strings inside
the canopy according to the number on the pic-
ture(1,2,3).
3. Fasten the button to the Vertical Leg.(4)
4. Repeat step2,3 according to the number on the
picture(5~10).