Operation Manual

1110
RF-14-GB(V2)
WARNING: Do not leave pool unattended while lling with water.
WARNING: If more than 1~2 inches of water collects on any one side before you
start lling in the center.The pool is not level enough, and must be corrected! You
shall pull out the drain plug, release the water completely, disassemble the pool
completely,locate the pool on a plane surface, repeat set up instructiion.
WARNING: DO NOT OVERFILL as this could cause the pool to collapse.In times of
heavy rainfall you may need to empty some of the water to ensure the level is correct.
PART5-FILL THE POOL WITH WATER
1. Make sure the drain tting is plugged securely and the cap
is in place. Start lling the pool with water. After about 1-inch of
water is on the bottom, stop lling and smooth wrinkles out of the
bottom of the pool. Pull the outer wall out from the top edge, all
around the bottom of the pool, so that it lls evenly.
2. Contineue lling the pool until water level .
Step5. INSTALL T-JOINT(FOR TYPE B)
4
3
4
5
1
2
1. Use the connection end of the T-Joint to connect
the adjacent horizontal tubes.
2. Insert the Pin into the hole of connected
horizontal tube and T-Joint rmly.
3. Install the vertical leg cap onto the vertical leg.
4. Insert the vertical leg into the T-Joint through the
belt.
5. Insert the pin into the hole of T-Joint and Vertical
Leg.
TIP: If you can’t nd the hole on the horizontal
tube or vertical leg please rotate the tubes until the
pin meets the hole.
PART4-SET UP THE POOL
BELT