Installation Guide

WWW.BOCCHIUSA.COM

Tools and Materials

Before You Begin

1. Preparation

Read these instructions carefully before you begin this installation.

Observe all local plumbing and building codes.

Shut off the hot and cold water supplies.

Inspect the drain and supply tubing. Replace if necessary.

Prior to installation, unpack the new sink and inspect it for damage. Return the sink to its protective carton until

you are ready to install it.

Due to the variety of installations possible with this sink, you may need to use procedures other than those

described.

It is very important that the proper materials are used with your sink. Proper selection of tile is critical for a

secure installation. Because of the variance in tile thickness, your carpenter, tiler, and plumber must be aware of

the exact type of tile you choose.

After selecting the tile, provide a sample to each contractor involved in the project. It is very important that the

carpenter, tiler, and plumber maintain communication and discuss the requirements of the project.

The cabinet and frame shown in these instructions are generic and may not represent the actual design or structure.

Due to the nature of undercounter installations, BOCCHI recommends that undercounter sink installations be

performed by trained and experienced installers.

To ensure a safe and damage-free installation, two people should install the sink.

All information in these instructions is based on the latest product information available at the time of publication.

 BOCCHIreservestherighttomakerevisionsinthedesignofproductswithoutnotice,asspeciedinthe 

Price Book.

Undercounter Installations

Check to see if the faucet can be completely assembled to the countertop and the sink.

Determine this by taking the countertop thickness plus the sink rim thickness, 5/8" (1.6 cm) plus or minus

1/32" (1 mm), and comparing that measurement to the available shank length between the base of the

faucet assembly and the mounting nut. If the available shank length is the same or longer than needed, proceed.

If not, select a thinner countertop or another faucet.

CAUTION: Risk of personal injury or product damage. Handle with care. Product can

break, chip, cause injury or product damage if handled carelessly. Get help lifting the sink.

Sealant

Drill

Pencil

Tape

Measure

Safety

Glasses

Plus:

• 1/2"orlargerdrillbit

• Holesaw1-3/8"

• Supportframemembers

• Sandingblock

• Assortedsandpaper

• Orbitalsander(optional)

Bodelair