Installation Guide

3
WWW.BOCCHIUSA.COM
2. Cabinet/Support Frame Construction
Measure the size of the sink, including the apron (the top of the apron is approximately 1/4" (6 mm)
wider than the top). The cabinet opening should equal the maximum sink/apron dimensions to ensure
a minimum gap between the sink and the cabinet.
NOTE:Ifthesinkisnotavailableatthetimeofinstallation,makeallowancestoaddwoodllerstripsorspacersto
the cabinet opening after the frame and before the sink is installed.
 Determineifthesinkwillbeushwithorextendslightlybeyondthefrontofthecabinet.Thesinkmayextend
no more than 1-1/4" (3.2 cm) beyond the face of the cabinet.
 Constructawoodsupportframetotinsidethecabinetopening.Allowadequateclearanceforthewatersupply
 linesbetweenthesupportandthenishedwall.
Locate and cut out the drain outlet clearance hole in the support. The hole diameter must clear the garbage
disposal mounting system, if used.
Dimension "H"
Max Sink/
Apron Width
Cabinet
Sink Outline
TOP VIEW
1-1/4" (3.2cm) Max
Drain Hole
Cabinet Perimeter
Support
Frame Members
Running
Front-to-Back
(Typical)
17" (43.2cm)
Support and Frame
Wood Filler
Strips/Spacers
Finished
Wall
Support (must clear water supply lines)
3. Support Frame Installation
Undercounter and Solid Surface Installations
Position the support frame in the cabinet opening so that when installed, the top of the sink will be level and
 ushwiththetopofthecabinet(DimensionH).
Water Supply Lines
Frame Members
Support
Dimension "H"
17" (43.2cm)
Support and Frame
Drain Outlet
Clearance Hole
WWW.BODELAIR.COM