Installation Guide

Installation Instructions
For Undermount Sink
Please carefully read complete instructions before beginning installation. these
instructions are for installation with solid surface, composite material countertops.
Recommends professional countertop installers and is not
responsible for damage to the countertop or sink during installation.
1. Unpack the new sink and check the contents of the materials supplied: Sink, Mounting
Brackets ,strainer and Cutout template (depending on model).
2. Supplied cutout template provides follow options of installation:
A. Flush mount: Sink edge is flush with countertop opening.(FIGURE 1)
3.Cut out the appropriate template for your sink model and desired installation option
.
Place template in desired position on countertop , locating center of the bowl over cabinet
and faucet holes .
4.Trace the outline of the template and cut countertop acoording to templated outl
ine suing
appropriate cutting tools. Template is for guide only. Use physical sink to ensure accurate
cutout opening .(FIGURE 2)
5.Locate the drill holes on the underside of the countertop, approximately 1"from edge of
the sink to be installed. Holes should be evenly spaced approximately 6" to 8"apart starting
from every corner as shown in(FIGURE 3). It is recommended to install a faucet at this point
before installing the sink.
Fastener
Mounting bracker
Countertop
Silicone caulk
(not fumished)
Sink
Cut inside of ling
Counter Top
Cut out area
FIGURE 1 FIGURE 2 FIGURE 3