User's Manual

Information
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions,
1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that
may cause undesired operation.
FCC RF Radiation Exposure Statement
1. This equipment complies with FCC RF radiation exposure limits set forth for
an uncontrolled environment.
2. This device and its antenna must not be co-located or operating in conjunction
with any other antenna or transmitter.
LED LASER FOR CLASS 1
NOTE:
This equipment has been tested and found to comply with the limits for a class B
digital device, pursuant to Part 15 the FCC Rules . These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions , may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception ,
which can determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures,
●
Reorient or relocate the receiving antenna
●
Increase the separation between the equipment and receiver
●
●
Connect the equipment into an outlet on a circuit different form that to which the
receiver is connected
●
Consult the dealer or an experienced radio/TV technician for help
●
Products with the CE Marking comply with the EMC Directive and the Low Voltage
Directive issued by the Commission of the European Community.
Troubleshooting
When the keyboard and mouse do not work properly, the common troubleshooting
steps.
4. Press the connect button on the back side of the mouse and keyboard for
5 seconds. While the receiver blinks, release the connect button.
1. Take the receiver out from your PC. After few seconds, plug the receiver into your
PC again.
2. Make sure if the batteries are positioned correctly and connected well.
3. Please check to make sure that the batteries are not dead.
I 08 I 07
Caution!
The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the
user authority to operate the equipment.