User Manual

jjPlus Corp.

15F-7, No, No. 2, Jianba Road, Zhonghe District, New Taipei City, 235

TEL: +886-2-2248-5700 FAX: +886-2-2248-5977

11. If there are metal structural parts such as table feet or brackets under the non-metallic table, there

shall be at least above 35mm safety distance between the wireless charger and the metal structural

parts.

12. If there are immovable metal objects inserted on the non-metallic table, there shall be at least above

35mm safety distance between the wireless charger and the metal objects.

13. When multiple wireless chargers are installed side by side, the distance between the wireless

chargers must be at least 300mm, so as not to interfere with each other and affect the charging

efficiency and function.

NOTE: This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates uses and can radiate radio

frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception, which

can be determined by turning the equipment off and on, the user is encouraged to

try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by the party responsible for compliance

could void the user's authority to operate the equipment.

This device complies with Part15 of the FCC Rules. Operation is subject to the following

two conditions:

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may

cause undesired operation.