users manual
8
BlueDriver-F3 Wireless Audio Interface
Bluetooth Wireless Technology
Disconnecting from a Device
To disconnect from a device, turn o
Bluetooth on your phone or power
o the connected headset/device.
Alternatively, turn o the BlueDriver.
If left unused in Idle or Pairing Mode, the
BlueDriver will automatically disconnect in
two minutes and power o.
Turning o BlueDriver-F3
From the powered-on state, hold the
<Connect> button for 5 seconds, then
release to turn o BlueDriver-F3.
If the blue LED continues to ash or blink after
releasing, then the <Connect> button was:
a) released too early.
b) held more than 10 seconds.
c) pressed after BlueDriver-F3 was left
unused and powered o automatically.
Connection History
BlueDriver retains a history of the
16 most recent devices. To clear
connection history and return to
factory default, with the BlueDriver
powered o, set the switch to the
<Headset> or <Phone> position, then
hold the <Connect> button in for at
least 20 seconds. After resetting, the
BlueDriver will return to Pairing Mode.
Reconnect to Paired Devices
To reconnect to a device saved in
Connection History, the BlueDriver
should be in Idle Mode (see page 4)
and the Role Select Switch in the
correct position. BlueDriver-F3 will
automatically connect to a paired
device that is Bluetooth-enabled,
powered-on and within range.
Note: Connecting via Bluetooth wireless
technology varies with dierent cell phones.