users manual

1. Connect Button
The <Connect> button is used to
turn on the BlueDriver and initialize
connections (Pages 6-7). This
button is also used to disconnect
and turn o󰀨 the BlueDriver (Page 8).
2. Role Select Switch
Before you turn the BlueDriver
on, be sure to set the Role Select
Switch to the correct position.
If you change this switch while the unit is
on, you will need to power the unit o󰀨, then
power the unit back on before the change
takes e󰀨ect.
Select <Headset> if you will
be using your BlueDriver with a
Bluetooth enabled headset or any
device that emulates a headset.
Select <Phone> if you will be using
your BlueDriver with a cell phone
or other master device. Please
note that wireless phones typically
cannot receive A2DP stereo audio.
3. Power
BlueDriver should be fully charged
before its rst use. While this
battery will normally charge in
about 2 ½ hours, please allow 4-5
hours for this rst charge, or until
the LED turns o󰀨.
2
Getting to know your BlueDriver-F3
BlueDriver-F3 Wireless Audio Interface
Headset
Connect
Phone
BlueDriver-F3
™
JK Audio
™
1 2
Power Rec
3 4