Owner's manual

ManualsBrandsJK Audio ManualsAccessories communicationComPack

03/07

JK Audio, Inc. 1311 E 6th Street, Sandwich, IL 60548 USA

Voice: (815) 786-2929 Toll Free: 800-JK-Audio Fax: 815-786-8502

Info@jkaudio.com www.jkaudio.com

ComPack is covered by a 2 year warranty to be free from

defective workmanship and materials. In the event that the

ComPack needs repair, you must call us to get an

authorization, and then carefully pack and ship it to us. You

will pay for shipping to us and we will pay for the return back to

you, UPS ground. No free repairs will be made if the defect

was caused by misuse, weather conditions, or other cause,

except for defective workmanship or materials.

THERE ARE NO EXPRESSED OR IMPLIED WARRANTIES

WHICH EXTEND BEYOND THE WARRANTY HERE MADE.

Warranty

User Guide

ComPack

Universal Telephone

Audio Interface

JK Audio

Summary of content (8 pages)

PAGE 1
Warranty ComPack is covered by a 2 year warranty to be free from defective workmanship and materials. In the event that the ComPack needs repair, you must call us to get an authorization, and then carefully pack and ship it to us. You will pay for shipping to us and we will pay for the return back to you, UPS ground. No free repairs will be made if the defect was caused by misuse, weather conditions, or other cause, except for defective workmanship or materials.
PAGE 2
FCC Registration (continued) Introduction be unplugged from the modular outlet until the problem has been corrected. Repairs to this telephone equipment can only be made by the manufacturer or its authorized agents or by others who may be authorized by the FCC. For repair procedures, follow the instructions outlined under the warranty section of the manual. ComPack is a universal telephone audio interface that connects to cell phones, PBX phone systems and standard analog phone lines.
PAGE 3
FCC Registration ComPack General Operation Your new JK Audio product has been registered with the Federal Communications Commission (FCC). This product complies with the standards in Part 68 of the FCC rules. 1. Connect your microphone (and/or line input) and headphones to the input and output jacks on ComPack. 1. 2.
PAGE 4
6. Phone Mix Output / Intercom Link 8. Keypad On / Off Switch Clip LED 4 JK Audio, Inc. ComPack Block Diagram 1/10/02 - WR 3.5mm Line Input XLR Input mic/line switch 1. Female XLR Input Level Control The Mic Input volume control adjusts the level of audio from the female XLR input. Adjusting this control determines the level of audio you send down the phone line from this input.* There is an LED that will indicate when your audio is clipping so you can decrease your input volume to avoid distortion.
PAGE 5
Specifications Inputs: Female XLR 3.5 mm Outputs: Male XLR 1/4” jack Features 1000 ohms, mic/line switch -35 dB pad Line level, 20k ohms, 250 mV, (-10 dBm) RMS Phone mix mode - balanced 600 ohms, 15 mV, (-25 dBm) RMS intercom mode - bi-directional unbalanced 8 ohms, 500 mW Power: One 9 volt battery or AC power supply (included) Size: 8” x 3” x 2.2” (20.3 x 7.6 x 5.6 cm) Weight: 1.5 lbs. Shoulder strap, wireless interface cable and one 9 volt battery included. 3.
PAGE 6
Features FAQs 9. ? How can I record my conversation? ! The balanced male XLR, in "Line Out" mode provides a nice mix Phone Line Switch This switch acts as the switch-hook for the telephone line. The Hang Up position is the normal on-hook position when you are not using the line or you are waiting for a call. When you want to place a call, or when a call comes in, switch to the Dial/Talk position. When using the Handset or Wireless Interface, the switch should remain in the Hang Up position at all times.
PAGE 7
FAQs Features ? How ! do I select which telephone interface to use (analog phone line, PBX, or wireless)? Actually, all three connections are live all the time. Technically, you could connect to all three at once, but since there is no way to equalize levels, this "conference call" might not be the best quality connection. 11. Battery Test Button / LED 12. Wireless Phone Interface Jack 13. 3.5 mm Line Input 14. Male XLR Output / Com Link 15.
PAGE 8
Features ComPack Telecom / Intercom Link 16. Female XLR Input The female XLR input can be used for either the connection of a dynamic microphone or a line level audio signal such as from an audio mixer. This input can be used at the same time as the 3.5 mm line input. ComPack also functions as a simple “no-frills” telecom link for your beltpack intercom system. ComPack will provide bi-directional audio on pin 3 of the male XLR jack to any industry standard intercom beltpack system.