User Manual

5
Connection
Although each application may require a slightly different setup,
there are two primary configurations.
For a direct connection to innkeeper PBX:
• Handset cable - Connect the supplied RJ-22 handset cable be-
tween the jack marked "Phone" on the back of innkeeper PBX
and to the handset jack on the base of your telephone.
• Handset - Connect your telephone handset to the RJ-22 jack on
the back of the innkeeper PBX marked "Handset".
• Send Audio - Connect a dynamic microphone cable to the Send
1 jack on the innkeeper PBX. Be sure to set the Mic/Line switch
to the “Mic” position.
• Output - Connect a stereo cable from the mini jack “Stereo Out”
on the innkeeper PBX to the “Line Input” on your computer
sound card, mini disk recorder or other equipment.
• Power - Connect the supplied DC power supply to the back of
the innkeeper PBX and then to an AC power outlet.
• Place a test call to a quiet location. Set the “A-B-C” switch on
innkeeper PBX for best audio.
• Set the “Send” level control so that while you are speaking into
the microphone, the Send LEDs on the hybrid light the -20 dB
green LED consistently and flash the -9 dB green LED. If you
flash the -3 dB red LED, lower the level. Set the “Caller” control
for good recording level of the caller audio at the output jack.
Sound Card
Line
in
Line
out
Mic
in
Set to
“Mic”
Computer