User Manual

9
Features
Power
RemoteMix 4 is powered by two 9 volt alkaline batteries located on
the side of the unit. The red Power LED on the front of the device will
gradually dim as the battery runs down, then extinguish about a half
hour before the unit shuts down. Since these two batteries are in
separate drawers and wired in parallel, you can hot swap one bat-
tery at a time so you never lose power.
It is important to replace both at the same time with identical
batteries. If two fresh batteries are not available, it is better to run
using only one good battery. Since the battery fixtures are wired in
parallel, it does not matter which one gets the single battery.
We also provide a high quality, regulated AC to DC adapter to power
RemoteMix 4 when AC power is available. Simply plug it into the
back of RemoteMix 4 and plug the transformer into a wall outlet. This
is a switching power supply so you can connect to a 110 or 220 VAC
power source. When the power connector is inserted into the jack,
the batteries are bypassed. The AC adapter does
not charge the
batteries. If you lose power during your broadcast, the RemoteMix 4
automatically reverts to battery power so your broadcast will not be
interrupted.
Make sure you use only the supplied AC power adapter with the
RemoteMix 4. Using any other adapter could damage the unit.
WARNING! It is strongly recommended that this
product be connected to an adequate surge protec-
tion device for the power line as well as the telephone
line at all times.