Owner manual

JKS2942JKS Adjustable End Links Installation

Page 1

INSTALLATION

INSTRUCTIONS

Product: Adjustable End Links

Part Number: JKS2942

Applications: Jeep Wrangler TJ, 1997-06

Welcome

CONGRATULATIONS on purchasing a set of new Adjust-

able End Links from JKS Manufacturing. We are committed

to providing you with the best products available and your

satisfaction is our rst priority.

PLEASE READ these Installation Instructions carefully,

and save them for future reference, as they contain impor-

tant installation and maintenance information.

Important

NOT COMPATIBLE WITH aftermarket swaybars. Install

product with Original Equipment swaybar only.

Tools Required

 Metric/Standard Socket Wrench Set

 Torque Wrench

 Tape Measure

 3/4” Open-End Wrench

 Medium Strength Threadlocker

 Wheel Bearing Grease

 Metal Cutting Tool * (such as die grinder with cutting

wheel or appropriate saw for cutting connecting rod)

 Factory Service Manual (recommended) *

* Asterisk denotes tools that are not required for some applica-

tions. Thoroughly read instructions rst to determine which tools

will be required for your application.

Parts

Description QTY

Connecting Rod 2

1/2” Jam Nut 4

Bushing Eyelet 4

1/2” Poly Hourglass Bushing 4

517-278-1226 • tech@jksmfg.com • www.jksmfg.com

491 W. Gareld Avenue, Coldwater, MI 49036

PAGE 1
Product: Adjustable End Links Part Number: JKS2942 INSTALLATION INSTRUCTIONS Applications: Jeep Wrangler TJ, 1997-06 517-278-1226 • tech@jksmfg.com • www.jksmfg.com 491 W. Garfield Avenue, Coldwater, MI 49036 Parts Welcome CONGRATULATIONS on purchasing a set of new Adjustable End Links from JKS Manufacturing. We are committed to providing you with the best products available and your satisfaction is our first priority.
PAGE 2
Rotate swaybar up and down to simulate full suspension travel. Check center of swaybar to ensure it does not contact axle housing. Installation 1. REMOVE ORIGINAL EQUIPMENT (OE) REAR SWAYBAR LINKS Also check angle of swaybar swing-arms in relation to lower rear suspension arms. Optimum performance will be achieved when these components are close to parallel. Remove the original mounting hardware that secures the rear swaybar links to the swaybar and chassis.
PAGE 3
Using an appropriate cutting tool (such as a die grinder with cutting wheel, or metal cutting saw), carefully and squarely cut each end of the Connecting Rod (A) where previously marked. Now completely unthread both 1/2” Jam Nuts (B) from Connecting Rod (A) and re-install. HINT: This will help to repair any thread damage that may have occurred during the cutting process. 4.