Manual

JKS9607JKS Bar Pin Eliminator Installation
Page 1
INSTALLATION
INSTRUCTIONS
Product: Bar Pin Eliminators™
Part Number: JKS9607
Applications: Wrangler JK, 2007+
Welcome
CONGRATULATIONS on purchasing new Bar Pin Elimina-
tors from JKS Manufacturing. We are committed to provid-
ing you with the best products available and your satisfac-
tion is our rst priority.
PLEASE READ these Installation Instructions carefully,
and save them for future reference, as they contain impor-
tant installation and maintenance information.
Important
NOT COMPATIBLE WITH Old Man Emu™ shock ab-
sorbers.
INSTALLATION OF BAR PIN ELIMINATORS effectively
reduces the static length of shock absorber by 0.40”.
Tools Required
 Metric/Standard Socket Wrench Set
 Torque Wrench
 Wheel Bearing Grease
 Bench Vice or C-Clamp
 Hammer and Punch *
 Sanding or Grinding Wheel *
 Factory Service Manual (recommended)
* Asterisk denotes tools that are not required for some applica-
tions. Thoroughly read instructions rst to determine which tools
will be required for your application.
Parts
Description Part # QTY
A
Cross Pin / Block Combo 03077 2
B
Mounting Block 03076 2
C
1/8” Roll Pin 64083 2
D
M10 x 50mm Hex Bolt 40698 4
E
Split Washer 40253 4
Installation
 1. REMOVE SHOCK ABSORBERS
 Remove the upper shock absorber mounting bolts
from the chassis bracket.
 Remove the lower mounting bolt and nut from the
axle bracket. Retain lower mounting hardware for
reassembly.
 Remove the rear shock absorbers from the ve-
hicle.
 Remove the factory bar pin from the upper shock
absorber bushing. Discard the factory bar pin and
upper mounting bolts. HINT: A hammer and punch
may be useful for removing factory bar pin.
517-278-1226 • [e-mail] • www.jksmfg.com
491 W. Gareld Avenue, Coldwater, MI 49036