Owner's manual
JKSOGS168JKS OE Replacement Rear Tackbar Bracket Installation
Page 3
4. REINSTALL REAR TRACK BAR
Apply anti-seize lubricant to bolt threads of original
track bar mounting hardware.
Insert axle end of track bar into Replacement
Bracket rst. Loosely install original mounting
hardware.
Mount chassis end of track bar and loosely install
original mounting hardware.
IMPORTANT: Vehicle must be on level ground with
coil springs supporting the full vehicle weight before
mounting hardware is tightened.
Using a torque wrench, tighten mounting hardware
at both ends of track bar to 125 ft-lbs.
Maintenance
Check torque specications regularly.
©2013 JKS Manufacturing, Inc & Aftermarketing, LLC
Revision Date 11/1/2013