Owner's Manual

Apply Loctite® red thread-locking compound to two M6

x 16 mm Machine Screws, slide them through the slots

in the clamp receiver, into the appropriate holes in the

xture base, and fully tighten.

Realign the clamps with the clamp receiver on the

enclosure, and secure them to the clamp receiver using a

pair of M6 x 45 mm Machine Screws, M6 Flat Washers,

and M6 Locknuts as illustrated, and fully tighten. Note:

e locknut should be installed into the hex shaped

recess on one end of each clamp.

Remove the center M6 x 16 mm Machine Screw from the

clamp receiver, apply Loctite® red thread-locking

compound, reinstall, and fully tighten.

Remove adhesive backing and install the JL Audio logo

badge.