Installation Instructions for all PS-SWMCP swivel fixtures for round pipes PI PE M O U N T I N G FIX T U R E S (S W I V EL ) FOR PS650-VE X™ ENCLOSED SPEAKER SYSTEMS
1 Loosen the pre-installed M4 x 4 mm Set Screw in the clamp receiver. Slide an M6 x 16 mm Machine Screw through the center hole of the clamp receiver, into the center hole in the fixture base, and hand tighten. 3 Secure the clamps to the clamp receiver using a pair of M6 x 45 mm Machine Screws, M6 Flat Washers, and M6 Locknuts as illustrated. The locknut should be installed into the hex shaped recess on one end of each clamp.
5 Apply Loctite® red thread-locking compound to two M6 x 16 mm Machine Screws, slide them through the slots in the clamp receiver, into the appropriate holes in the fixture base, and fully tighten. 7 Realign the clamps with the clamp receiver on the enclosure, and secure them to the clamp receiver using a pair of M6 x 45 mm Machine Screws, M6 Flat Washers, and M6 Locknuts as illustrated, and fully tighten. Note: The locknut should be installed into the hex shaped recess on one end of each clamp.
9 If you wish to rotate the speaker’s grille/logo badge alignment, remove the six #8 x 1-1/4” speaker mounting screws and #8 Flat Washers. 11 For best adhesion, it is recommended to clean the inside of the aluminum cap with acetone (not included) prior to attaching it to the enclosure. Apply a circular bead of silicone adhesive to the inside of the aluminum logo cap, about 1/2-inch (13 mm) from the outer edge. 10 Rotate the speaker to the desired angle.
For LED Models Only: LED Fuse Blue Yellow Fuse LED LED Blue Example: One speaker pair of LED circuits connected in parallel. [GND] [+12V] Fuse Yellow Fuse Blue Yellow Fuse LED LED Blue Yellow Fuse Blue Example: Two speaker pairs of LED circuits connected in parallel. [GND] [+12V] Fuse Yellow Fuse LED Blue Yellow • For marine installations, do not connect the speaker’s LED lights to the vessel’s navigational lighting circuits.
Included Hardware: (hardware pictured for one) Mounting Fixture is made in the USA by Axia Alloys Protected by US Patents #8,136,771 & #8,398,035
BOM ID Quantity Description 1 4 2 3 4 6 2 4 Axia Alloys Strap Clamp M6 x 16 mm Socket Cap Machine Screw 5 2 Clamp Receiver 6 1 Loctite® Red Thread-Locking Compound 7 4 M6 Flat Washer 8 4 M6 x 45 mm Socket Cap Machine Screw 9 1 Plastic Strip 10* 2 Fixture Base 11* 1 Silicone Adhesive 12* 12 #8 Flat Washer 13* 12 * Included with VeX™ speaker enclosures.
LIMITED WARRANTY - MARINE PRODUCTS (USA) JL AUDIO warrants this product to be free of defects in materials and workmanship for a period of two (2) years from the original date of purchase. This warranty is not transferable and applies only to the original purchaser from an authorized JL AUDIO dealer.