Owner's Manual

Loosen the pre-installed M4 x 4 mm Set Screw in the

clamp receiver. Slide an M6 x 16 mm Machine Screw

through the center hole of the clamp receiver, into the

center hole in the xture base, and hand tighten.

Secure the clamps to the clamp receiver using a pair of

M6 x 45 mm Machine Screws, M6 Flat Washers, and M6

Locknuts as illustrated. e locknut should be installed

into the hex shaped recess on one end of each clamp.

Hand-tighten, allowing just enough freedom to rotate the

enclosure around the pipe.

Place the supplied plastic strip around the pipe to

prevent scratching. Push the clamps over the pipe

(remove the plastic strip). Align the clamps with the

clamp receiver on the enclosure.

Position the enclosure at the desired location, tightening

the M6 x 45 mm Machine Screws as necessary. Fully

tighten the pre-installed M4 x 4 mm Set Screw in the

clamp receiver to hold its position. Mark the location

of the clamps on the pipe, then remove the enclosure

from the pipe.