Installation Instructions for M-LCA-C-W & M-LCB-C-W LED LIGHT CAP FOR ETXv3 & VeX™ ENCLOSED SPEAKER SYSTEMS
Included Hardware: (hardware pictured for one) 2 3 NOTE: The M-LCA-C-W Light Cap and M880- ETXv3-SG-WH Enclosed Speaker System are used in this manual for illustrative purposes only. The installation steps are the same for all ETXv3 and VeX™ Enclosed Speaker Systems and all LED Light Caps.
Remove the six #8 x 1-l/4" Pan Head Screws and six #8 Flat Washers that secure the speaker to the enclosure. Disconnect the speaker wiring and speaker LED wiring (if equipped), and remove the speaker from the enclosure. Using the exterior angles of the JL Audio logo as a guide, mark the center of the rear aluminum logo cap, as shown. Using a punch tool, make an indent in the aluminum logo cap on the center mark.
Pass the LED wires and Threaded Stud on the back of the LED Light Cap through the drilled hole, and position the cap flush against the back of the enclosure. Slide an M10 x 1.5 Nylon Insert Flange Locknut over the LED wiring, and hand-tighten onto the Threaded Stud. Slide theM 10 Locknut Tool over the LED wires and onto the M10 x 1.5 Nylon Insert Flange Locknut. Rotate the LED Light Cap to the desired angle. Using the M10 Locknut Tool, fully tighten the MlO x 1.
Connect the LED wires from the LED Light Cap to the LED wires entering the enclosure. Refer to the wiring charts on the opposite page for details. DO NOT install the fuse holders inside the enclosure. Reconnect the speaker wiring, and reinstall the speaker using the six #8 x 1-1/4" Pan Head Screws and six #8 Flat Washers.
Example: One pair of LED circuits connected in parallel. q~Red V o Black - 8 eo~~.__~F-u_s_e ____._r_ : .... _ __. q~Red v 0 Black ....\..... Example: Two pairs of LED drcuits connected in parallel. q V o ~Red Black _........ Q~Red v o Black _ ... • For marine installations, do not connect the LED lights to the vessel's navigational lighting circuits. • For short circuit protection, install a supplied fuseholder onto EACH LED Light Cap's RED (+12V) LED power connection lead.
BOM ID , ..,... 1 Quantity Description MlO Locknut Tool 1 . ~-.v - -~-----~~-•" ""~ ' •-·---·-"·•--·~- .--•··~~·-" -----r~ •·-·~· --·-·m~~---· ·,v~--,._,.,~---··--·-· ·,·.·-~v-• . . .- ·-·-··-····-·.."2j ..... ...··-··-----· ··-r·I · ,_ _ . L YV~·· ·.·.---.-.·.·.·.·· · w....·.· 2 ....... ·- · ·- ··-·-···· · ·--·~· -· ·-2· ... .· -_, . MlO x 1.5 Nylon Insert Flange Locknut ··- ·- ~ 4* 2 LED LigEt_~~P Threaded Stud s• 2 0-Ring --- .. - .. - lSOmA Fuse (not shown) 2 ••w o.·.·.
LIMITED WARRANTY- MARINE PRODUCTS (USA) JL AUDIO warrants this product to be free of defects in materials and workmanship for a period of two (2) years from the original date of purchase. This warranty is not transferable and applies only to the original purchaser from an authorized JL AUDIO dealer.
