Owner's Manual

Rotate the speaker to the desired angle. Reinstall the
speaker and speaker mounting screws and washers.
Hand-tighten the screws in a criss-cross pattern.
For best adhesion, it is recommended to clean the inside
of the aluminum cap with acetone (not included), prior
to attaching it to the speaker enclosure.
Apply a circular bead of silicone adhesive (included) to
the inside of the aluminum logo cap, about 1/2 inch (13
mm) from the outer edge.
12 13
Align the aluminum logo cap to the desired angle of
rotation, and press it onto the back of the enclosure.
Apply masking tape (not included) to hold the cap in
place until the silicone cures (at least 24 hours).
14