Installation Instructions for M-SWMCPv3-1.315 • M-SWMCPv3-1.660 • M-SWMCPv3-1.900 M-SWMCPv3-2.000 • M-SWMCPv3-2.250 M-SWMCPv3-2.375 • M-SWMCPv3-2.
IMPORTANT IMPORTANT: Swivel mounting fixtures should only be attached to horizontal pipes. ETXv3 enclosures should only be mounted directly above (12 O’clock position) or directly below (6 O’clock position) a horizontal pipe. WARNING WARNING: Do not mount enclosures to a horizontal pipe in any position other than directly above or directly below. WARNING NOTE: The M-SWMCPv3-2.000 fixture and M770-ETXv3-SG-WH Enclosed Speaker System are used in this manual for illustrative purposes only.
1 2 128.5 205.5 -- -O- - - - -e- Be sure the indicated stopping points are on opposite sides of the fixture as shown. The enclosure can rotate up to 205.5 degrees in the clockwise direction, and 128.5 degrees in the counter-clockwise direction. 3 In applications that require the logo to be inverted, remove the two #8 -32 x 3/8” machine screws and lock washers.
5 Adjust the angle of the fixture until level, mark the location for the speaker cable hole. Remove the fixture assembly, and drill a 1/2” hole on the mark. 7 Remove the four 1/4 - 20 x 1-1/4” machine screws and 1/4” lock washers to separate the two upper halves of the fixture. Pass the speaker cable exiting the enclosure through the opening on the underside of the fixture.
9 Have a helper support the enclosure during this step. Use the supplied butt connectors to connect the red (+) and black (-) speaker cable exiting the ETXv3 enclosure to the speaker cable exiting the pipe. The green and white wires will not be used in this application. 11 Align the two upper halves of the fixture around the pipe. Hand-tighten four 1/4 - 20 x 1-1/4” machine screws with 1/4” lock washers into the fixture. DO NOT TIGHTEN FULLY AT THIS POINT.
13 14 -o-,. _ __ _ Remove adhesive backing and install the JL Audio logo badge (Sport Grille Models Only). 15 Rotate the speaker to the desired angle. Reinstall the speaker and speaker mounting screws and washers. Hand-tighten the screws in a criss-cross pattern. If a different speaker angle is desired, remove the speaker mounting screws and washers. 16 Rotate the enclosure to the desired angle, install the 5/16 - 18 x 1/2” set screw into the base of the fixture, and fully tighten.
17 For best adhesion, it is recommended to clean the inside of the aluminum cap with acetone (not included), prior to attaching it to the speaker enclosure. Apply a circular bead of silicone adhesive (included) to the inside of the aluminum logo cap, about 1/2-inch (13 mm) from the outer edge. 18 Align the aluminum logo cap to the desired angle of rotation, and press it onto the back of the enclosure. Apply masking tape (not included) to hold the cap in place until the silicone cures (at least 24 hours).
LIMITED WARRANTY - MARINE PRODUCTS (USA) JL AUDIO warrants this product to be free of defects in materials and workmanship for a period of two (2) years from the original date of purchase. This warranty is not transferable and applies only to the original purchaser from an authorized JL AUDIO dealer.
