Owner's Manual

BEFORE YOU BEGIN INSTALLING
• Turn offthe audio system. It is also advisable
to disconnect your battery system whenever
performing installation work.
• Before cutting, drilling or inserting any screw,
check clearances on both sides ofthe planned
mounting surface. Also check for any potential
obstacles, such
as wiring harnesses, fuel lines,
hydraulic lines, etc. Check both sides
of the
vessel before cutting any holes.
• Wear protective eyewear at all times and a dust
mask and gloves when drilling or cutting.
IIIWARNINGI
It is absolutely vital that your coaxial speaker
system is connected as shown in this manual.
Failure to connect the system as shown will
result
in damage to your speakers which
is
NOT covered under warranty. Do not
substitute different crossover networks!
IIICAUTIONI
While these speakers are designed to bewater
and spray resistant, theyare not designed tobe
submerged or to withstand high-pressure water
spray. Please exercise care when washing your
boat
to avoid damaging your speakers. Do not
install on submersibles, personal watercraft or any
other vessel likely to be under water at anytime.
Prolonged exposure
to sound pressure levels in
excess of lOOdB can cause permanent hearing
loss. This high-performance speaker can
exceed this level. Please exercise restraint in its
operation
in order to preserve your ability to
enjoy its fidelity.
When installing speakers in your vessel, it is
extremely
important to secure them firmly. This
applies
not only to the speakers themselves,
but also any structure they are mounted to. If
not firmly attached, the speakers can become
dangerous projectiles
in a collision. Please
review the
mounting information carefully and
use the supplied marine-grade hardware to
mount this product.
TWEETER PROTECTION
The crossover networks are equipped with
an advanced electronic tweeter protection circuit
designed to minimize the possibility
of tweeter
failure. This electronic device monitors current
going
to the tweeter and will disconnect the
tweeter from the signal when
it senses overload.
Should this occur while listening to the audio
system, simply reduce the volume for a
few
seconds and the protection circuit will reset
itselfautomatically.
4 I JL Audio ~ M6S0~CCX / M770~TCX / M770~CCX Owner's Manual