Owner's Manual
Table Of Contents
TWEETER
PROTECTION
The crossover networks are equipped with
an advanced electronic tweeter protection circuit
designed to minimize the possibility of tweeter
failure. This electronic device monitors current going
to the tweeter and will disconnect the tweeter from
the signal when it senses overload. Should this occur
while listening to the audio system, simply reduce the
volume
for
a
few
seconds and the protection circuit
will reset itself automatically.
INTERCHANGEABLE
LOGO
BADGE
(Sport-Grille
Models
Only)
Interchangeable Logo Badges for Sport
Grille model coaxial speakers are included to
further customize your installation.
The
design
of
the Sport Grille allows for
the
JL
Audio logo
to be added
in
your choice
of
included colors and
oriented
in
the
manner
that best suits
your installation.
NOTE: A left and a right badge
of
each
color
is
included. These two different
orientations ensure the
"JL
Audio" Logo will
read correctly wherever positioned (most
commonly the 3:00 or 9:00 position).
Remove the adhesive backing from the badge
and affix the badge to the grille using the small
positioning hole
as
a guide. See diagram below.
3:00 Position
9:00 Position
1--::"_
4 I
JL
Audio-
MX650-CCX
I
MX770-CCX
Owner's Manual
BEFORE
YOU
BEGIN
INSTALLING
• Check with your local waterway authority
for any regulations regarding the use
of
accent/speaker lighting
on
your vessel.
• Turn off the audio system.
It
is
also advisable
to disconnect your battery system whenever
performing installation work.
• Before cutting, drilling or inserting any screw,
check clearances
on
both
sides
of
the planned
mounting
surface. Also check for any potential
obstacles, such
as
wiring harnesses, fuel lines,
hydraulic lines, etc. Check
both
sides
of
the
vessel before cutting any holes.
•
If
you are
running
cables through bulkheads,
drill holes for the cable and use a urethane
or
plastic
grommet
to protect the wire from
chafing in the hole. Make sure that
the
cables
will clear any mechanical devices
in
the
boat
and secure
them
with wire ties.
• Wear protective eyewear at all times
and
a dust
mask and gloves when drilling or cutting.
If
you have any questions about the installation
or setup
of
your coaxial speaker system
not
covered
in
this manual, please contact your
dealer or technical support.
JL
Audio Technical Support:
(954) 443-1100
9:00AM
- 5:30
PM
(Eastern Time Zone)
Monday
- Friday