Owner's Manual

Apply Loctite· red thread - locking compound to two M6
x 16 mm Machine Screws. slide them through the slots
in the damp receiver. into the appropriate holes in the
fixture base, and fully tighten.
Realign the damps with the damp receiver on the
endosure, and secure them to the damp receiver using a
pair of M6 x 45 mm .Machine Screws, M6 Flat Washers ,
anJ M6 Locknuts as illustrated, and fully tighten . Note :
The locknut should be installed into the hex shaped
recess on one end of each damp.
Remove the center M6 x 16 mm Machine Screw from the
damp receiver, apply Loctite" red thread-locking
compound, reinstall, and fully tighten.
Remove adhesive backing and install the JL Audio logo
badge.