Manual

Page 6 • JL Audio, Inc., 2016 Continued on Next Page
STEP 24
Reinstall the seat belt latches, and hand tighten
the two 5/8” Hex Bolts.
STEP 23
Slide the Stainless Steel Cushion Clamp around
the pipe on the passenger side, and align the
holes in the clamp with the threaded insert on
the side of the enclosure.
Thread a 1/4 - 20 x 1” Stainless Steel Serrated
Flange Bolt through the Stainless Steel Cushion
Clamp, into the threaded insert, and hand
tighten.
STEP 22
Slide the Top Bracket up and under the rear
upper panel, then align the holes in the
Bottom Bracket with the seat belt brackets as
shown.
STEP 21
Remove the adhesive backing from the Right
Side Heat Shield, align the holes in the Right
Side Heat Shield with the holes in the back
of the enclosure, and secure with #8 x 1/2”
Stainless Steel Phillips Pan Head Screws.
Repeat for the Left Side Heat Shield.
STEP 20
Align the holes in the Bottom Bracket with the
threaded inserts in the bottom of the
enclosure, and secure with two 1/4 - 20 x 1”
Stainless Steel Serrated Flange Bolts, as shown.
STEP 19
Align the holes in the Top Bracket with the
threaded inserts in the top of the enclosure,
and secure with four 1/4 - 20 x 1” Stainless Steel
Serrated Flange Bolts, as shown.
STEP 18
Apply Foam Tape to the back of the Top
Bracket as shown.
STEP 17
Remove the 5/8” hex nut from each seat belt
bracket, and move the seat belt latches out of
the way.
SB-POL-RZG2R/10TW3 INSTR_SKU# 011463