Manual

Page 6 • JL Audio, Inc., 2016 Continued on Next Page
STEP 32
From the front of the rear lower panel, align
the Grille Trim within the recess in the center
of the panel, with the Grille Trim’s narrow side
positioned at the top.
Using a 1/8” drill bit, drill pilot holes through
each of the six holes in the Grille Trim and into
the rear lower panel.
STEP 31
Pictured is the back of the rear lower panel
with the factory heat shield removed.
STEP 30
From the back of the rear lower panel, remove
the four clips from the factory heat shield, and
remove the shield.
The factory heat shield will not be reinstalled.
STEP 29
Apply Foam Tape to the front of the enclosure
as shown.
STEP 28
Connect speaker cable to the barrier strip on
the driver side of the enclosure, and route the
cable as necessary.
STEP 27
Fully tighten the 1/4 - 20 x 1” Stainless Steel
Serrated Flange Bolt on the side passenger side
of the enclosure.
STEP 26
Fully tighten the 5/8” Hex Bolt on each seat
belt bracket.
STEP 25
Align the outer holes in the Top Bracket with
the factory holes in the rear upper panel.
SB-POL-RZG2R/10TW3 INSTR_SKU# 011463